KELLPAST® NO EUGENOL
No eugenol impression paste for edentulous

PRESENTATION
Kit includes:
- One tube Base x 150 Gr.
- One tube Catalyst x 50 Gr.
USES
Eugenol free impression paste for use in preparation of full or partial dentures in edentulous patiens.
CHARACTERISTICS
- Indicada para pacientes con tejidos lesionados
- KELLPAST® NO EUGENOL is easy to mix and to handle.
- KELLPAST® NO EUGENOL remains workable in patient’s mouth for a better impression adaptation.
- KELLPAST® NO EUGENOL set with good hardness to prevent distortions.
- Product to be used by the professional dentist.
INSTRUCTIONS FOR USE
MATERIAL MIXING
- Use a clean and dry slab or a paper mixing pad.
- Squeeze onto the slab equal lengths of Base and Catalyst. Tube must remain always closed while not in use.
- Mix the two KELLPAST® NO EUGENOL pastes with a spatula and when a soft and homogeneous mixture and a uniform color is obtained (1 minute mixing time) the KELLPAST® is ready to use.
HOW TO USE KELLPAST® NO EUGENOL AS CORRECTIVE IN THE BITE IMPRESSION
- Remove impression from the tray and trim excess around margins. If necessary soften edges with flame. Then return the impression to patient’s mouth to adapt it.
- Dry palatal surface of the impression.
- Mix KELLPAST® NO EUGENOL paste and cover palatine impression surface with a one to two millimeters layer.
- Have patient rinse mouth with cold water. Insert the impression, slowly adapting it in order to allow paste to flow into all tissue irregularities. Avoid compression by the modeling compound especially if there are soft or spongy areas in the mouth. When case is properly seated, have patient close mouth and suck in cheeks.
- If the impression is not completely satisfactory, dry the surface and add more KELLPAST® NO EUGENOL where necessary, placing impression back into the mouth. Repeat as many times as necessary until getting a perfect impression.
HOW TO USE KELLPAST® NO EUGENOL AS A CORRECTIVE IN THE FINAL IMPRESSION
KELLPAST® NO EUGENOL can be used as a corrective of final impression, following previous instruction.
POURING THE MODEL
No separator is required with KELLPAST® NO EUGENOL. Pour the model in any plaster.
CLEANING SPATULA AND GLASS SLAB
Allow the excess of the mix to harden on the slab, and then scrape with a knife. For better results use KELLPAST® NO EUGENOL. Base with KELLPAST® NO EUGENOL Catalyst.

